---- host configuration for Ethernet ----
L) Ethernet Local ip address : 192.94.45.212
S) Ethernet Subnet Mask : 255.255.255.0
T) Ethernet Type : Ethernet/DIX
X) exit
Use L to set the IP address for this SCC card. Use S to set a Subnet mask which is appropriate for the Ethernet segment to which the SCC card will be connected.
Use the T command to select the mode of operation, this will be Ethernet/DIX if you are running a typical TCP/IP network.
Note that changes made to the SCC card Ethernet configuration do not take effect until the card is rebooted. See boot.