Verilink NCC Craft Port -- DIAGNOSTICS --

The Diagnostics command is used to enter the Diagnostics menu for the currently selected card. The user first enters "D", then the diagnostics menu appears. For some cards there are very few diagnostic functions, so they are included in the Configuration menus. This applies to the DIU2130 and DIU2140 cards. Click here to see the diagnostics menu for a TAC2130 or NCC2130 card.
Shown here is the diagnostics menu for an NCC2020 or TAC2010 card.


CSU DIAGNOSTIC -- FW Rev 1.2  HW Fab 0.8  Type NCC 2020 --



                       |-----------------------|

                       |                       |

-------&LT;&LT; eq  &LT;&LT;-------|----------|f|----------|-------&LT;&LT; net &LT;&LT;-------

                       |          |r|          | PULSES

                       |          |a|          |

                       |          |m|          |

 PULSES                |          |e|          |

------->> eq  >>-------|----------|r|----------|------->> net >>-------

                       |                       |

                       |-----------------------|

 X) exit menu      Y) enable loops   Z) reset alarm    T) test time (FOREVER)



 __eq loops__      __err counter__   __net signals__   __net loops__

 R) repeater       A) show cntr      1) qrss           L) line

 E) equip          B) clear cntr     2) 3 in 24        P) payload

                                     3) 1 in 8         U) inband up

                   N) end tests      4) all 1          D) inband down

Return to NCC Craft Tutorial